hasemsp.blogg.se

Macbook g4 power supply
Macbook g4 power supply




macbook g4 power supply
  1. #MACBOOK G4 POWER SUPPLY INSTALL#
  2. #MACBOOK G4 POWER SUPPLY ZIP#

#MACBOOK G4 POWER SUPPLY ZIP#

ribbon cable from the CD/DVD and Zip drivesĥ.Disconnect the following cables from the back of the CD/DVD/Zip drives (Figure 5): Carefully detach the ribbon cable tape from the top of the carrier. Supporting the bottom of the carrier, slide it back and rotate it so you can reach the drive cables. With a Phillips scewdriver, remove the three screws that attach the CD/DVD drive carrier to the chassis. While you may remove the power supply from your computer, you should not open the power supply case for any reason, even when the computer is off.ġ. Warning: The power supply is a high-voltage component. Close the side access panel and shut down the computer before proceeding. Warning: If you see any lights glowing on the main logic board, the computer has not been shut down. To avoid scratching the case, lower the panel onto a soft, clean cloth. Gently lower the access panel until it lies flat. Lift the latch on the right side access panel.ĩ. To avoid static electricity building back up in your body, do not walk around the room until you have completed the installation and closed the computer.Ĩ.

#MACBOOK G4 POWER SUPPLY INSTALL#

Important: To avoid electrostatic discharge, always ground yourself by touching the port access covers before you touch any parts or install any components inside the computer. Touch the metal PCI access covers on the back of the computer. Unplug all other cables from the computer except the power cord.Ħ. If you attached a security cable through the computer’s lockable cover latch, remove the cable.ĥ. Shut down your computer and wait five minutes before continuing.Ĥ. If you think your computer is in sleep, press the power button on the front of the computer to wake it.ģ. Place your computer on a clean, flat surface.Ģ. Let the computer cool down before continuing.ġ. After you shut down the computer, the internal components can be very hot. Warning: Always shut down your computer before opening it to avoid damaging its internal components or causing injury.

  • 2.5 mm Allen wrench Opening the Computer.
  • This procedure requires the following tools: Warning: During this procedure, keep small parts away from chlldren. Note: Written and video instructions covering customer-installable parts are available at. Failure to follow these instructions could damage your equipment and void its warranty.
  • PowerBook G4 15-inch FW800 (Foot Replacement)įollow the instructions in this sheet carefully.
  • PowerBook G4 (Titanium 400 and 500MHz) 02.
  • PowerBook G4 (Gigabit Ethernet 550 667 MHz) 02-06.
  • PowerBook G4 (17-inch, Double Layer Super Drive).
  • macbook g4 power supply

    PowerBook G4 (15-inch, Double Layer Super Drive).






    Macbook g4 power supply